河上镇2011年全年工作总结及2012年工作思路.docVIP

河上镇2011年全年工作总结及2012年工作思路 2011年是“十二五”规划的开局之年，也是河上建设省级中心镇的起步之年。面对今年国内外形势的新变化、新特点，我镇在区委、区政府的正确领导下，紧紧围绕年初所制定的具体目标和“打造省级中心镇，建设富裕新河上”的总目标，按照“合力发展、特色发展、绿色发展、和谐发展、创新发展”的工作要求，真抓实干，开拓创新，攻坚克难，强经济、保民生、促和谐，推动了全镇经济社会又好又快发展。 一、2011年工作回顾 （一）重抓举措，内外整合，工业经济稳步发展 一年来，我镇始终坚持以经济建设为中心，实施“工业强镇、兴镇”战略，大力推进工业 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning , length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad head crimping, fell down, causing an open circuit. After wiring, may be tried