Linux流量监控nload.docVIP

Linux流量监控工具nload 个人觉得nload是个很好用的一个工具,功能也很强.只是相对单一,只能查看总的流量, 可以实时地监控网卡的流量,分Incoming,Outgoing两部分,也就是流入与流出的流量同时统计当前,平均,最小,最大,总流量的值,使人看了一目了然,如下图 安装wget http://www.roland-riegel.de/nload/nload-0.7.2.tar.gztar zxvf nload-0.7.2.tar.gzcd nload-0.7.2./configure;make;make install 安装nload-0.6.0.tar.tar解压安装报错，通不过。之后要下了个nload-0.6.0-1-mdk92.i586.rpm格式的，安装了！ nload-0.6.0-1-mdk92.i586.rpm的安装命令 ： rpm -ivh nload-0.6.0-1-mdk92.i586.rpm 使用直接用nload回车即可,也可以指定网卡,如nload eth1还可以指定是以K或M来显示流量,如nload -u M显示的流量是以MB为单位的 看看还有哪些参数或选项[root@wdlinux ~]# nload -h nload version 0.7.2Copyright (C) 2001 - 2008 by Roland Riegelnload comes with ABSOLUTELY NO WARRANTY. This is free software, and you arewelcome to redistribute it under certain conditions. For more details see theGNU General Public License Version 2 (/copyleft/gpl.html). Command line syntax:nload [options] [devices]nload --help|-h ?Options:-a period Sets the length in seconds of the time window for averagecalculation.Default is 300.-i max_scaling Specifies the 100% mark in kBit/s of the graph indicating theincoming bandwidth usage. Ignored if max_scaling is 0 or theswitch -m is given.Default is 10240.-m Show multiple devices at a time; no traffic graphs.-o max_scaling Same as -i but for the graph indicating the outgoing bandwidthusage.Default is 10240.-t interval Determines the refresh interval of the display in milliseconds.Default is 500.-u h|b|k|m|g Sets the type of unit used for the display of traffic numbers.H|B|K|M|G h: auto, b: Bit/s, k: kBit/s, m: MBit/s etc.H: auto, B: Byte/s, K: kByte/s, M: MByte/s etc.Default is h.-U h|b|k|m|g Same as -u, but for a total amount of data (without /s).H|B|K|M|G Default is H.devices Network devices to use.Default is to use all auto-detected devices.--help-h Print this help. example: nload -t 200 -i 1024 -o 128 -U M 如安装时提示下面的问题configure: error: ncurses library or development files not found. ncurses is required for nload.make: *** No targets specified and no mak