（HSE管理文件）FREP-04-HSE-2010.doc

福建项目ROJECT CONSTRUCTION 钢结构安装程序 STEEL ERECTION PROCEDURE 文件编号DOCUMENT NUMBER: FREP-04-HSE-2010 PROCEDURE 目 录 TABLE OF CONTENTS 编号No. 页码Page 1.0 目的PURPOSE 3 2.0 范围SCOPE 3 3.0 定义DEFINITIONS 3 4.0 职责RESPONSIBILITIES 10 5.0 指导INSTRUCTIONS 10 6.0 参考资料REFERENCES 32 7.0 附件ATTACHMENTS 32 1.0 目的Purpose 1.1 本程序提出在施工、改造和/或修复单层和多层建筑物、桥梁和其它构筑物时进行钢结构安装的过程中确保员工不受钢结构安装工作相关危害的起码要求。 This procedure provides the minimum requirements to protect employees from the hazards associated with steel erection activities involved in the construction, alteration, and/or repair of single and multi-story buildings, bridges, and other structures where steel erection occurs. 2.0 范围Scope 2.1 本程序适用于项目中从事钢结构安装的人员、分包商以及厂商。本程序不包括槽罐。 This procedure applies to employers, subcontractors, and vendors engaged in steel erection in FREP project. This procedure does not cover tanks. 3.0 定义Definitions 3.1 锚定剪刀撑──钢托梁剪刀撑与剪刀撑终点连接。 Anchored Bridging ── the steel joist bridging is connected to a bridging terminus point. 3.2 螺栓连接式对角支撑（剪刀撑）──采用螺栓连接于钢托梁或其它托梁的对角支撑。 Bolted Diagonal Bridging ── diagonal bridging that is bolted to a steel joist or joists. 3.3 剪刀撑固定夹──该固定夹装置附着于钢托梁上，以便允许采用螺栓将剪刀撑连接于钢托梁。 Bridging Clip ── a device that is attached to the steel joist to allow the bolting of the bridging to the steel joist. 3.4 剪刀撑终点──指提供钢托梁对角支撑锚固点的墙壁、梁、串联托梁（安装有全部剪刀撑构件和上弦杆平面的水平桁架）或位于对角支撑线末段或中点的其它部件。 Bridging Terminus Point—a wall, a beam, tandem joists (with all bridging installed and a horizontal truss in the plane of the top chord) or other element at an end or intermediate point(s) of a line of bridging that provides an anchor point for the steel joist bridging. 3.5 索具──用于将负荷连接于升降机装置的钢丝绳或合成纤维绳索的吊装用具。 Choker ── a wire rope or synthetic fiber rigging assembly that is used to attach a load to a hoisting device. 3.6 冷成型──意指在常温下使用压弯机、轧棍或其它方法将钢铸成预期