cpuz_readme_cn.docVIP

cpuz_readme_cn CPU-Z 自读文件 Version 1.57 版本号 1.57 February 2011 2011年02月 Contact : cpuz@ 联系我们 ：cpuz@ Web page: /cpuz.php 网站：/cpuz.php Validation page : 确认页面 ： Hall of Fame : /records.php 名人堂 :/records.php Forum : /forumdisplay.php?f=74 社区 ：/forumdisplay.php? CPUID SDK : /devkits.php CPUID SDK介绍 ：/devkits.php Configuration file (cpuz.ini) 配置文件 (cpuz.ini) The configuration file must be named cpuz.ini and be present at the same directory level as cpuz.exe. It contains the following : 配置文件必须存放在cpuz.exe. 同一文件夹下名字为cpuz.ini [CPU-Z] TextFontName=Verdana TextFontSize=13 TextFontColor=000060 LabelFontName=Verdana LabelFontSize=13 PCI=1 MaxPCIBus=256 DMI=1 Sensor=1 SMBus=1 Display=1 ShowDutyCycles=0 UseDisplayAPI=1 - TextFontName : Font used for the information boxes. 信息框字体样式 - TextFontSize : Size of the font used for the information boxes. 信息框字体大小 - TextFontColor : Color of the font used for the information boxes. Value is expressed in hexadecimal, and consists in a classic Red/Green/Blue color code : RRGGBB 信息框使用字体颜色。RBG颜色：RRGGBB/000060 - LabelFontName : Font used for the label boxes. 标签框字体样式 - LabelFontSize : Size of the font used for the label boxes. 标签框字体大小 - Sensor : Set to OFF (or 0) disables sensor chip detection and voltages measurement. 1 to enable.传感器检测设置，1为开启、0为关闭 关闭后将不显示温度及电压 - PCI : Set to OFF (or 0) disables the PCI information. This disables chipset, SPD and, depending on the hardware, sensoring information. 1 to enable.PCI检测设置，1为开启、0为关闭 关闭后将不会显示主板、SPD及硬件传感器信息 - MaxPCIBus : Sets the maximum PCI bus to scan. Default value is 256. - DMI : Set to OFF (or 0) disables the DMI (Desktop Management Interface) information. This concerns BIOS vendor and version, motherboard vendor and revision. 1 to enable. DMI设置，1为开启、0为关闭。管壁厚 - SMBus : Set to OFF (or 0) disables SMBus information : SPD, and, depending on the hardware, sensoring information. 1 to enable.SMBUS设置，1为开启、0为关闭 关闭后将不会显示主板、SPD及硬件传感器信息 - Display : Set to OFF (or 0) disables the video card information reported