ACER 470Z本本维修全过程.docVIP

ACER 4720Z本本维修过程 现象：键盘左边10个键不能用，换了新键盘也一样 第一步，取下电池，然后取下红色标志的螺丝 第二步拿下开机盖板，取下开机板 第三步，拿下键盘 第4步，拿下后面的盖子，拆掉硬盘，内存，无线网卡，然后把后盖红色的螺丝都取下 第5步，拿下光区，把红色标志的螺丝取下，把屏目拿下来 第6步，取下红色标志的螺丝，就可以把前盖那下来 第7步，把主板的螺丝取下，就可以拿下主板 第8步测试键盘排线接口的对地阻值，MY的正常阻值在680K左右，MX的正常阻值在600K左右，开始MY0对地阻值才300K，导致键盘左边10个键不能用，拆下主板测试发现一脚的阻值从300K恢复到680K，正常， 那肯定是外接的东西导致阻值偏低，我就装回一个配件，测试一下阻值，发现是开机板引起的，接下来就验证一下，直接看看开机板上的开机键，连到排线的第几针，直接短接它和地线，开机，新键盘OK，然后换回旧键盘测试一下，还有4个键不行。 这本本，是因为进水，把键盘和开机板搞坏了。 the oil level to the normal oil level. (2) for the secondary prevention of the leakage of cooling water pipe fittings, valve parts before installation to check ... 4.2 measures to eliminate quality defects of cables cable laying in front of the cable construction, design, supervision and construction units to deliver the design, and drawing the third. Combined the engineering field to find fault, adding omitted items. Because the unit used computer DCS control and adds a great deal of control and signal cables. So you should carefully review, checks for missing physical cable, ready for construction and to verify cable length, specifications, familiar with the cable channel and the device location and bracket cable bracket on the section number. At the time of preparation of the inventory of cable, first of all, the professional carefully study electrical schematics, in accordance with the principle of accounting the cable path cable volume, the number of cores used, total volume and design inventory check cable to cable with and without omission, laying of the cable in order to ensure the process does not put a cable one cable. Finally, at the time of inventory, prepared to take the same path the cables together. Inventory preparation is completed, later in each enclosure affixed on both sides of each side of the cable you want to lay accurately verify cable lengths and set aside. Bridge should be combined, correcting errors, avoid straight, no cable bridge scaffolding used in the construction, not allowed to use ele