542010图学与人机交互设计.docVIP

图形学与人机交互设计（542010）教学大纲 01．教学单位：软件学院 02．课程编号：课程名称：课程英文名称：Computer Graphics nteractive Technology 05．课程学时：48学时，其中含实验 20 学时 06．课程学分：2.5学分 07．课程类别：学科基础课 08．课程性质：选修 09．开课学期：第 5 学期 10．面向专业：软件工程 11．选用教材，徐长青、许志闻、郭晓新，《计算机图形学》，机械出版社，2010年。 12．主要参考书 1. （美）赫恩 著，（美）巴克 著，蔡士杰，宋继强，蔡敏 译电子工业出版社 2010 2.孙家广，胡事民 计算机图形学基础教程 清华大学出版社 2009. 13．课程教学目的与任务 图形学与人机交互设计是一门计算机专业基础课，是计算机专业本科生必修的专业基础课。本课程介绍图形显示及图形表示的方法和原理。通过本课程的学习，使学生了解计算机在图形应用方面的基础原理，了解图形应用中的特殊性处理方法，掌握人机交互程序设计，进而懂得计算机在数值领域深入应用的方法，为问题的解决提供适宜的模型和办法。 14．课程教学基本要求C++程序设计。 16．课程教学内容 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jac