ftp快捷方式资源管理式打开)图文教程.docVIP

ftp快捷方式(资源管理式打开)图文教程 创建好之后的效果图， 打开效果图： 下面是创建步骤：跟着做100%成功！！！！！！！ 打开网上邻居： ——〉 在“网络任务”列表中点 “添加一个网上邻居” ——〉 点两个下一步之后： 在这里输入ftp的地址，如我的：ftp://stu@50 注：是你在ftp里创建的用户名，我的是没密码的，名为:stu 是你主机的IP地址。最好主机不要用自动获取IP，自己设定为好。 下一步是快捷方式的名称，默认是IP，可自行修改。 ——〉 点下一步，就可以完成了， 可以把图标拖到桌面上。这时恭喜你，成功了！！！！！！！ manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jack uses the same pump, evenly. B) left to set up indicators to monitor over quantity. To prevent the movement over the Chamber when the platen, at the top of the front bearing plate installed tight, then anchor base next to the corresponding