FANUC数控统PLC授 课 方 案.doc

编号：LNJD-PR08-RE08 授 课 方 案 授课教师 课程名称 数控机床PLC技术应用 单元 授课时间 年 月 日 年 月 日 第 周 第 周 星期 星期 第 节 第 节 授课章节 FANUC数控系统PLC 教学目标 知识目标：理解FANUC数控机床PMC规格 能力目标：掌握FANUC 程序编写概要 素质目标：学会顺序程序的概念 重点 难点 西门子数控机床PLC程序 教学地点 普通教室□ 一体化教室□ 多媒体教室□ 实训室□ 实验室 □ 企业现场□ 其他 教学方法及手段 常规教学□ 启发式教学□ 现场教学□ 案例教学□ 问题教学□ 项目教学□ 多媒体教学□ 演示教学□ 其他 教 学 过 程 设 计 组织教学 课程导入 新课讲授 总结 教学后记 辽宁学院教案用纸 授 课 内 容 辽宁学院教案用纸 授 课 内 容 辽宁学院教案用纸 授 课 内 容 辽宁学院教案用纸 授 课 内 容 辽宁院教案用纸 授 课 内 容 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs,