google地地形导出及等高线生成.docVIP

SU里面找到项目位置点选择区域然后调整大小点右上角捕捉点一下这个他就有地形了他是锁定的右击解锁然后文件导出三维OBJ格式模型选项默认文件导入找到刚刚导出的OBj格式的文件 这时候模型角度需要反转一下在右视图变动-旋转-90度完了选中模型曲面-嵌面点确定他就生成一个曲面把原来的删掉留着嵌面生成的选了以后在前视图模型最底下?点一下按着shift在模型最高点之上点一下然后输入等高线距比如2500然后按enter他就在生成等高线完了以后曲面删掉留等高线文件另存为CAD就弄好了 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction guide pin coupling with process end closed. The back wheels slowly tightened, when 2mm or so, with standard white bars where two back wheel bolt hole measurement above and below, confirm two back wheel bolt hole concentricity. Then, the symmetrical horizontal