HP6L打印机障处理技巧.docVIP

HP5L/6L激光打印机的信号灯有三个，由上到下分别为错误灯（黄色）、数据灯（绿色）、准备好灯（绿色）。每种灯有三种状态：灭 闪烁? 亮 HP5L/6L激光打印机信号灯提示故障及排除： 信号灯状态 故 障 原 因 故 障 排 除 打印机缓冲内存中有未打印的数据 按下前面板按钮，打印残留的数据 1.打印机缺纸；2.打印机前门打开；3.硒鼓没安装或安装不正确；4.卡纸；6.接口板损坏；76.DC板损坏。 1），正确放纸；2）关闭前门；3）正确安装硒鼓；4）清理被卡住的纸；（特别是加热器下面的出纸传感器的回位）； 1.打印的内容太复杂； 1）减少打印作业的复杂程度；2）在WINDOWS或软件中将打印分辨率减小为300dpi；3）打印机增加可选内存；4）按下前面板按钮继续打印，但有可能丢失数据。 安装的内存不兼容 1.加热定影器损坏；2.DC板损坏。 1、激光扫描器错误；2、激光扫描器故障引起；3.DC板损坏。 1.激光器错误；22.DC板损坏。 1.接口板错误及损坏；2.并口打印电缆。 1）拔下打印机电源插头并再插上；2）断开并口打印电缆，再执行打印机自检，如果自检成功，重插或更换打印电缆，并联机打印，测试PC到打印机的通讯；3）如果错误继续，检查接口芯片1284、1071，及更换接口板。 睡眠模式 如果打印机的LED均不亮：1）打印机处于睡眠状态，按前面板按钮或打开机盖：2）打印机未能电。检查电源线和电源输入：3）进行引擎测试打印确定引擎状态。如果测试成功，更换接口板。 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, r