matlab三图形绘制和动画制作实验报告.docVIP

MATLAB及仿真技术实验报告 课程名称： MATLAN及其仿真技术 任课教师： 机 房： 逸夫楼209 计算机编号： 569 实验日期： 2012.10.16 实验成绩： 实验班级： 学生姓名： 实验名称： 三维图形绘制和动画制作 实验设备 、设施： 计算机 Matlab7.0 实验要求： 1、首先应熟悉MATLAB7.0运行环境，正确操作。2、自主编写程序，必要时参考相关资料。 3、实验前应写出程序大致框架或完整的程序代码。 4、实验学时：2学时。 实验目的： 1、掌握三维图形绘画指令。 2、理解曲面图的绘制。 3、通过练习熟悉三维曲线和曲面图的绘制方法。 4、掌握动画制作的基本方法。 实验结果分析 四、实验内容和步骤 1、实验内容 （1）在区间内，有，，，要求： ① 以子图形式绘出与,与, 与以及同一标度同一幅图中的三个函数图； ② 绘出三维曲线。 （2）已知 绘制三维曲面图，并进行插值着色处理。 （3）用stem绘制离散图象：加网格线 （4）播放一个直径不断变化的球体。 2、实验步骤 （1）分析实验内容，写出程序大致框架或完整的程序代码。 （2） 信息工程学院 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment