迅雷科技福特新克斯1.6去水印一键自动升窗器关窗器实例安装说明书.docVIP

安装说明： 1、请查实所购买的升窗器是否与车型配套； 2、把钥匙打到ON位置，测试原车车窗升降是否正常； 3、拆开驾驶室左前门门板； 4、拔下车窗集中控制开关线束插头，将升窗器插头对插； 5、找出原车常电电源线与升窗器电源线用特配接线夹搭接； 6、找出中控锁锁车输出信号线，（连接在马达电机上的，按下遥控器锁车键时，此线瞬间有12V正电输出）与升窗器预留信号线用特配接线夹连接； 7、将关窗器主机出线口向下固定在内饰板内合适位置； 8、检测升窗器系统功能是否正常； 9、将内饰板复位，完成！ 产品属性： 种类：电动 材质：进口 电压：大于等于9V 品牌：迅雷科技 型号：专车专用 产地：中山 电源电压：12V 认证：UL 升降时间：5S 使用寿命：15年 重量:0.1kg 主机 尺寸：27*19*7cm 外包装 10.3*8*1.5cm 主机，含外突出部分 自锁力：大于等于30kg 技术参数及规格：? 技术参数? 工作电压：11V-13V 工作电流：6A 静态电流：8mA 保护电流：9.5A 保护时间:6秒 流入ACC最低电压:9V 电动窗技术参数? 工作电压:11V-15V 工作电流:12A 静态电流:3mA 适用温度：+80—-20 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge block