汽油发电机安全作规范.docVIP

河北华讯微通网络集成有限公司 汽油发电机安全操作规范 为保证员工人身安全、基站设备安全、发电机安全，特按工作步骤制定本规范。要求发电人员、维护维修人员严格遵守。 注：由于各项目现多使用科勒（KOHLER）汽油发电机，故在本制度以该型号发电机为例进行说明。 基本安全操作规范 持证上岗！！！ 不得抽烟操作！！！不得酒后操作！！！操作工具应绝缘！！！ 油机附近不得有火源！！！周围2米内无易燃、易爆物品检查机油油位是否符合规定要求：取出机油油位标尺，将油位标尺擦拭干净后插入油机机油箱，取出后确认油机机油量在油位标尺的下端位置。 2、检查进风、排风通道是否畅通，有无异物遮挡、堵塞。检查油机各桩头螺丝是否紧固。确认停电后，关闭内其他负载空开（空调空开等）。依照断电流程（先低压后高压，先负载空开后隔离空开）逐级进行断电：关闭开关电源内整流模块空开→关闭开关电源内市电输入空开→关闭内市电输入空开→关闭内交流输入主空开。小知识： 因为电机本身绕组的电阻和电感都很小电机启动的一瞬间，相当于短路，电流是相当大的。在电机关断的时候也会产生一个反向的冲击电流。先接零线，再并接三相火线火线与零线依照逐级送电流程：打开油机供电空开→打开内开关电源供电空开→打开开关电源内交流输入供电空开→打开单块整流模块。检查开关电源内直流输出电压是否正常基站设备是否工作正常交流输入主空开上端确认来电后，依照断电流程逐级进行断电：关闭开关电源内整流模块空开→关闭开关电源内市电输入空开→关闭内开关电源交流输入空开→关闭内油机供电空开。依照逐级送电流程：打开交流输入主空开→打开内开关电源供电空开→打开开关电源内交流输入供电空开→打开所有整流模块。恢复交流配电箱内其他交流供电设备的供电（空调等）确认所有基站设备是否正常工作并通知已结束发电作业。整理基站机房清洁 移动油机应急发电安全规范 and performance test copies of the record. If necessary, review should be carried out; 4 for spring hangers included simple spring, hangers and constant support hangers it should also be recognized as setting and locking of loads. 5 check the surface quality, folded layering and without cracks, rust and other defects. 5 after completion of the test and control drawing number one by one, by series baled. Color alloy steel parts, the parts marking installation location and rotation about the direction you want. 7.3.14. hangers installation 7.3.14.1 hanger layout a. a clear design of hanger should be installed strictly in accordance with the drawings and designs shall not be installed wrong, missing, etc. B. own arrangement of piping support and hanger set and selection should be based on comprehensive analysis of general layout of piping systems; cold installation of steam pipe with particular attention reserved for compensation of thermal expansion displacement and orientation. C. support systems should be rational to withstand pipe loads, static load and incidental load; reasonable piping displacement; guaranteed under various conditions, stress are within the allowed range. Strength, stiffness