计量经济学(第版)李子奈 课后答案(部分).docVIP

其中，2表示第二章，其他一类推，本文档为2-5章部分题答案 and performance test copies of the record. If necessary, review should be carried out; 4 for spring hangers included simple spring, hangers and constant support hangers it should also be recognized as setting and locking of loads. 5 check the surface quality, folded layering and without cracks, rust and other defects. 5 after completion of the test and control drawing number one by one, by series baled. Color alloy steel parts, the parts marking installation location and rotation about the direction you want. 7.3.14. hangers installation 7.3.14.1 hanger layout a. a clear design of hanger should be installed strictly in accordance with the drawings and designs shall not be installed wrong, missing, etc. B. own arrangement of piping support and hanger set and selection should be based on comprehensive analysis of general layout of piping systems; cold installation of steam pipe with particular attention reserved for compensation of thermal expansion displacement and orientation. C. support systems should be rational to withstand pipe loads, static load and incidental load; reasonable piping displacement; guaranteed under various conditions, stress are within the allowed range. Strength, stiffness, and meet requirements to prevent vibration and soothing water, without affecting the adjacent equipment maintenance and other piping installation and expansion. D. equipment connected to the interface to meet pipeline thrust torque limit requirements; increase the stability of piping systems to prevent pipeline ... Tube wall thickness mm 2-3 4-6 7-10 weld form no slope mouth weld strengthening height h mm 1-1.5 1.5-2 weld width b mm 5-6 7-6 has slope mouth weld strengthening height h mm 1.5-2 2 weld width b mm cover had each edge slope mouth about 2 mm argon arc welding weld strengthening surface height and width tube wall thickness mm 2--3 3--4 5--6 weld form weld strengthening height h mm 1-1 .5 1.5-2 2-2.5 width b mm a