女神级别两种发变大脸.doc

相关专题：发型DIY瘦脸发型中分发型 ??????? style1 中分女神发 ??????? 中分的微弯弧度巧妙地修饰两颊婴儿肥，搭配内弯的下摆有收缩视线效果，小脸感瞬间提升！ ??????? 1.尖尾梳不守则分边 ??????? 以尖尾梳尾端将前发1:1中分，不需笔直，稍微不守则线条即可。 ? ??????? 2.下摆进行内弯卷度 ??????? 电卷棒夹住发束中段，向内卷耳下位置，松开后将卷度拨松。 ? ??????? 3.前发吹出内弯弧度 ??????? 将发根撑起吹出松感，再以圆梳往吹出微弯的前发弧度。 ? ??????? 4.拨松发根做出膨感 ??????? 将五指插入发根拨松，做出头顶的膨度让整体感更协调。 ? ??????? Style2 清爽度100%露额造型 ??????? 头发中分后，将两侧前发顺着发流向下编入，做出头顶的方形轮廓，搭配露额造型，脸意外地拉长！虽说露出较大的脸部面积，但却意外的有成熟小脸的感觉。 ? ??????? 1.发束进行反股编 ??????? 将发束分成三份，进行往下编入的反股编，即可做出三维感发辫。 ? ??????? 2.发辫在侧边固定 ??????? 编好的辫子在尾端以小黑夹固定，藏在耳朵后方位置即可。 ??????? 3.辫子往两侧拉松 ??????? 造型完成后，用手指将辫子两侧拉松，松柔辫子有修饰小脸效果。 瘦脸网 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and n