vlan配置电主机IP地址.doc

整个网络的框架 配置电脑主机IP地址 假设网络中存在三个Vlan，分别是Vlan10、Vlan20和Vlan30，三个Vlan的接口分别是192.168.10.254、192.168.20.254、192.168.30.254 规定PC0和PC1属于Vlan10，他们的IP地址分别为192.168.10.1和192.168.10.2，他们的网关地址为192.168.10.254 规定PC2和PC3属于Vlan20，他们的IP地址分别是192.168.20.1和192.168.20.2，他们的网关地址为192.168.20.254 规定PC4属于Vlan30，他的IP地址为192.168.30.1，他的网关地址为192.168.30.254。分别设置各个PC机的IP地址 配置网关地址 分别设置各个PC机的网关地址，PC0和PC1的网关是192.168.10.254 PC2和PC3的网关地址是192.168.20.254， PC4的网关地址为192.168.30.254。 设置交换机之间的连接为中继模式 要设置为中继模式的接口有SB中的Fa0/22-24，SC中的Fa0/23-24，SA中的Fa0/22-24 配置SB的Vlan 配置SC的Vlan 配置三层交换机的Vlan 配置三层交换机SA与路由器之间的接口 配置路由器Router0，及Nat 快速以太网的0/0接口为对外接口，接Router1 FastEthernet1/0为对内的接口，接三层交换机的21号端口 Nat接口的配置，内部网络对外网使用的地址池为202.110.4.3到202.110.4.9 配置动态路由Rip协议 配置三层交换机SA的动态路由 十一、配置Router0的动态路由RIP 十二、配置上层路由的接口 Router1与Router0之间的连接接口为快速以太网0/0接口 Router1连接Router2的接口 Router1连接Router3的接口 Router2连接PC5的接口 Router2连接Router1的接口 Router2连接Router3的接口 Router3连接PC6的接口 Router3连接Router2的接口 Router3连接Router1 PC5的IP地址及网关 PC6的IP地址及网关 十三、配置上层路由的RIP Router1的Rip配置 Router2的动态路由RIP配置 Router3的动态路由配置 the Communist Party of China, and a deep understanding of the partys nature, purpose, guiding principles, goals, organization, good style, deeply understand the conditions, rights and obligations of members, code of conduct, bearing in mind that oath, clear Members of the standards and conditions, enhance respect, abide by the Constitution, maintaining the party Constitution consciousness of the party Constitution. Read through the familiar with the code of self-discipline of the CPC, the CPC disciplinary regulations, members of the Communist Party of China party regulations on rights protection Ordinance, mastering self-discipline standards of four must, the four upholdings, mastering various types of disciplinary offence and punishment provisions and clear what you can do, what they cant do. 2. speech understanding learning series XI series the basic spirit of an important speech by General