abaqus的料参数.docVIP

Department of Engineering University of Cambridge?? Engineering Department?? computing help ABAQUS Materials Input 5. ABAQUS - Materials Q5.1 : How do I find what material properties are needed for a particular analysis ? Read the relevant section in Chapter 6 : Analysis Procedures (Users manual Vol. I). This gives an overview about the analysis and has more information about the material properties. Read also the following sections in Chapter 17 : Materials Introduction of the ABAQUS Users manual. Section 17.1.1 - Material Library : Overview Section 17.1.2 - Material Data Definition Section 17.1.3 - Combining Material Properties Section 17.1.3 lists the material model combination tables. Several models are available to define the mechanical behaviour (elastic, plastic). Some material options require the presence of other material options. Some exclude the use of the other material options. For example *DEFORMATION PLASTICITY completely defines the materials mechanical behaviour and should not be used with *ELASTIC. Once you have all the relevant keywords to define the material properties consult the keyword Manual for each of the keywords. This will explain what data is required for each of the keyword. Q5.2 : What material properties need to be specified in a thermal-electrical analysis ? Referring to Section 17.1.3 of the ABAQUS Users manual you will require the heat transfer properties as well as the electrical properties. These are listed below : Heat Transfer properties *CONDUCTIVITY *LATENT HEAT *SPECIFIC HEAT *HEAT GENERATION Electrical properties *DIELECTRIC *ELECTRICAL CONDUCTIVITY *JOULE HEAT FRACTION *PIEZOELECTRIC This forms the complete set of properties. If Piezoelectric elements are not used then *PIEZOELECTRIC and *DIELECTRIC properties will not be required. If only the steady state heat transfer response is of interest then *SPECIFIC HEAT properties are not required. Similarly if there are no phase cha