浙江省温州市乐虹桥实验中学2013届九年级百题竞赛数学试题.docVIP

a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter testing, it should meet the requirements. Install the coupling housings to ensure embedded rotor coupling within a concave shoulder, and rotor clearance meets the design requirements. 6.4, 6, wearing construction technology of generator rotors demonstration 6.4.6.1 construction preparation and conditions through the stator before loading check and confirm to confirm air tightness test of the stator and stator mechanical, electrical, instrumentation and control and other related work had been completed. Internal cleaning of stator, high power vacuum the surface of the stator. Stator and rotor magnetic Center drainage is complete. In conjunction with the quality, mechanical, electrical and other relevant persons to finally cleaning check the stator, which is clean and free of any debris. Worn rotors check and confirm confirm before loading the rotor air tightness test, electrical test work has been completed. In conjunction with the quality, mechanical, electrical and other relevant persons to finally clean the rotors checked, its interior is clean and free of any debris. By quality, mechanical, electrical and other professionals to conduct an examination of the rotor, confirm the wear condition of the rotor. Special equipment inspection and rotor through the preparation tool before loading inventory, check to confirm that it appears intact, complete tool, tools required for use of wire rope that has a factory certificate and test report; wire rope should select the safety factor ≥ 6; hoist testing qualified; road have been equipment authorized Visa temporary support ties should be a hardwood. Ends bearing end cover with connection of the stator plate or gourds by exclusive lug on the end face of a temporary low-hanging on the a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter