CCNA2012.11.11的题库.docVIP

CCNA2012.11.11的题库 CCNA（640-802）题库V104.4（2012.11.11） Exam A QUESTION 1 When you are logged into a switch, which prompt indicates that you are in privileged mode? A. % B. @ C. D. $ E. # Answer: E Section: Chapter 4: Introduction to Cisco IOS Explanation/Reference: 当你登陆一台交换机的时候，登陆到特权模式时，怎么显示的？ 考点分析：登入交换机，进去用户模式是使用作为提示符，进入特权模式是使用#号提示符. QUESTION 2 Which command shows system hardware and software version information? A. show configuration B. show environment C. show inventory D. show platform E. show version Answer: E Section: Chapter 4: Introduction to Cisco IOS Explanation/Reference: 那一条命令显示系统的硬件和软件版本信息？ 考点分析：这道题考的是show version这个基本的命令的作用。show version此命令的作用能显示系统的硬件和软件版本信息。 QUESTION 3 Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13. An 802. 1Q trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the native VLAN is not specified.What will happen in this scenario? A. 802.1Q giants frames could saturate the link. B. VLAN 10 on CAT1 and VLAN 1 on CAT2 will send untagged frames. C. A native VLAN mismatch error message will appear. D. VLAN 10 on CAT1 and VLAN 1 on CAT2 will send tagged frames. Answer: C Section: Chapter 10: VLAN Explanation/Reference: 交换机CAT1和CAT2通过F0/13端口连接， 交换机之间封装是的802.1q， 在VLAN10中本征VLAN被修改成了VLAN10,在CAT2上没有指定。这样配置就会出现什么情况? 考点分析：这道题考的是Trunk。Trunk链路的封装要求两边的本征vlan相同，如果不同，会出现VLAN不匹配这个错误。 QUESTION 4 Which command would correctly configure a serial port on a router with the last usable host address in the 2/29 subnet? A. Router(config-if)# ip address 8 40 B. Router(config-if)# ip address 9 24 C. Router(config-if)# ip address 3 48 D. Router(config-if)# ip address 9 48 E. Router(config-if)# ip address 3 48 F. Router(config-if)# ip address 8 48 Answer: F Section: Chapter 4: Introduction to Cisco IOS Explanation/Reference: 2/29它的块大小为8掩码为48地址范围为2-39 QUESTION 5 The network default gateway applying to a host by DHCP is 3/28. Which option is the vali