微星主板刷新BOS教程.docVIP

微星主板刷新BIOS图文教程 有一块微星主板，最近在玩大型游戏时经常出现卡机的情况，所以想刷新微星AMI主板的BIOS来解决这一问题，笔者也经常给客户刷新微星主板的BIOS，下面是刷新微星主板BIOS的详细过程，有兴趣的朋友可以按照寻修网/下面的步骤去刷新微星BIOS。 1、下载主板的最新BIOS，发现微星主板的最新BIOS 2、准备好一个U盘 因为用的是Win7的系统，即使是XP系统，Fat32格式的文件系统早该淘汰了，NTFS系统优点多多。但是却给DOS接口代来不便，进入DOS后，将不认NTFS，或者既使在NTFS加载了NTFS工具，也将支持不好。容易重启出问题。所以准备一个Fat32格式的U盘是很必要的。然后把下载的新BIOS解压到U盘根目录。 3、进入DOS。 4、进入U盘找到BIOS文件 找到这些文件 5、备份原来的BIOS。寻修网/注：这是因为怕新BIOS会出现某些问题，最好备份一下原来的BIOS。以看到里面有4个文件，现在我们打命令afu4310.exe +空格+140 开始刷新这里请注意必须打afu4310.exe，只打afdu4234是会报错显示无法刷新的 6、开始刷新BIOS。 7、重启电脑，看是否刷新成功。通过CPUZ测试，发现BIOS版本已经变成刷新的日期，说明刷新完成。 刷新主板BIOS有一定的风险性，但只要细心设置，刷新主板BIOS也不用那么担心，上面寻修网/刷新微星主板BIOS就是这样一气呵成的。 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two