映泰BIOS刷教程!.docVIP

★★★★ AMI BIOS刷新说明 ★★★★ ★用主板自带的“F12”键刷新 1、准备一个U盘，将U盘格式化为FAT32格式，将BIOS文件放到U盘根目录内（请不要放在解压的文件夹内否则无法识别BIOS） 2、开机插入放有BIOS文件的U盘，按F12键-从菜单中选择U盘-进入BIOS刷新程序界面，选择对应的BIOS文件按回车刷新，刷新过程提示两次Y 都选Y就会开始执行BIOS刷新过程，刷新完成按回车键重启电脑 具体刷新图解说明请登录下面网址查看： /app/en-us/support/faq.php?S_ID=411 ★★重要★★ 请导入默认值--操作方法如下： 重启电脑按F1进入CMOS中--选择进入EXIT---Load optimized defaults 回车选Y，然后F10保存设置！ 如网上BIOS无特殊说明要求使用其他工具刷新，请选择此方式刷新 刷新BIOS有风险请谨慎操作！请勿在升级bios程序文件时关闭或重新启动系统!此举将会导致系统损毁! 注意：AMD主板更新BIOS前，如有开核或超频，请先导入CMOS出厂默认值后在进行更新BIOS动作，否则可能刷新后不开机！ 1. F12 主板自带更新方式(推荐使用） 1. Press F12 for BIOS POST Flash 1-1. F12进入BIOS POST Flash 1-2. Select drive,依配备选择?Update BIOS装置来源,例如：USB ZIP或Floppy..等 1-3. 选择要update 的BIOS,并注意?Model Name及Chipset是否正确 1-4. 询问是否确定要?Update : Are you sure to flash BIOS (Y/N)? Y (按Y) -5. 询问是否清除?DMI资料： Erase DMI Date (Y/N) ?? Y (按Y) 1-6. Update BIOS 1-7. Update BIOS完成,询问是否要重开机：BIOS Flash done,Reset system (Y/N)? Y(按Y) Update过程中无当机、重开机后无错误讯息或无不正常开机现象,即完成Update BIOS stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance be