CCNA Exporation 4 Accessing the WAN Chapter 5.docVIP

CCNA Exploration 4 Accessing the WAN Chapter 5 1Which three parameters can ACLs use to filter traffic? (Choose three.)234packet sizeprotocol suitesource addressdestination addresssource router interfacedestination router interface 2Interface s0/0/0 already has an IP ACL applied inbound. What happens when the network administrator attempts to apply a second inbound IP ACL?1The second ACL is applied to the interface, replacing the first.Both ACLs are applied to the interface.The network administrator receives an error.Only the first ACL remains applied to the interface. 3A network administrator needs to allow traffic through the firewall router for sessions that originate from within the company network, but the administrator must block traffic for sessions that originate outside the network of the company. What type of ACL is most appropriate?3dynamicport-basedreflexivetime-based 4 Refer to the exhibit. ACL 120 is configured inbound on the serial0/0/0 interface on router R1, but the hosts on network /24 are able to telnet to network /16. On the basis of the provided configuration, what should be done to remedy the problem?1Apply the ACL outbound on the serial0/0/0 interface on router R1.Apply the ACL outbound on the FastEthernet0/0 interface on router R1.Include the established keyword at the end of the first line in the ACL.Include a statement in the ACL to deny the UDP traffic that originates from /24 network. 5 Refer to the exhibit. The administrator wishes to block web traffic from 0 from reaching the default port of the web service on 0. To do this, the access control list name is applied inbound on the router R1 LAN interface. After testing the list, the administrator has noted that the web traffic remains successful. Why is web traffic reaching the destination?4Web traffic does not use port 80 by default.The access list is applied in the wrong direction.The access list needs to be placed closer to the