毕业设计(论文)－简易数控钻床加工过程控制仿真与实现.docVIP

西安培华学院 本科毕业论文（设计） 题目 简易数控钻床加工过程控制仿真与实现 姓 名 院 系 计算机科学与技术 专 业 网 络 工 程 学 号 指导教师 简易数控钻床加工过程控制仿真与实现 摘 要 该设计系统是以AT89S51为单片机，用74LS245为显示位控制，软件程序采用C语言编写，便于移植与升级。报告详细介绍了整个系统的硬件组成结构、工作原理和系统的软件程序设计：Is simple number control the drilling machine transform process control to imitate really with realize Abstract This text introduced the design method that the number controls the drilling machine control system hardware telephone. The designs system is to take AT89 S51 as unipole slab machine, use the 74 LS245s as display potential control, take advantage of unipole slab machine, stepping dynamo and it the additional telephone design a system that the sequence process that carries out logarithm to control drilling machine controls. Establish the system as one dimensional coordinates, system from number control machine and dynamo drive circuit 4 LED displays and acceleration, decelerate, is screwing, turn over key composition, pass to weave a distance, realize vs the velocity variation of stepping dynamo, even soon, and just, anti the display control of the run - time and run - time status.The software procedure adoption C language writes, easy to transplantation with upgrade. The report introduced the hardware composition of the whole system in detail structure, work the software programming of priniple and system apply it with homologous of software, this system constituted a complete number to control drilling machine control system.It can not only be the control system that the number controls drilling machine, also available set against the number of common drilling machine to control a remould.The drill has even soon, velocity variation, positive and negative revolution function, pass the run - time that the funtion key cutover carries out various operate status, pass and measure soon a loop and forming a can control of shut ring system, realize display dynamo run - time the velocity will have in