多功能数显半径测试仪英文说明书.docVIP

MULTI-INDICATORS OPERATION AND CARE MANUAL To take full advantage of Multi-indicators,read this mannual thoroughly before using it.After reading ,retain this manual for future reference.Specifications of Multi-indicators and the information in this manual are subject to change without notice. Introduction 1.While measuring the radius of arc,measuring it using R gages commonly,but application range of R gages is limited,because it only measure standard radius of arc,and getting data from comparison measurement,so cant getting accurate data of workpiece.Multi-indicators can measure random radius of arc,apply for measurement radius of arc and plastic mould manufacturing. 2.Multi-indicators have five different length measuring jaws,for choose corresponding measuring jaws,while measuring arc face. 3.Multi-functions 1)Application as indicators 2)Outside measurement 3)Inside measurement 4)Depth measurement 5)Step measurement Nomenclature Measuring Jaws The LCD The control panel Measuring spindle Spherical measuring head Data output Battery lid Clamping bolts The base The panel Display radius of acr Display length,while measuring arc,display chord data Data hold Inch/Metric changeover Measuring jaws changeover Functions changeover Data output Zeroset and Power off OPERATIONS Power on Short pressing key:ZERO/ON/OFF Zeroset Short pressing key:ZERO/ON/OFF,can zeroset at any locations.Before inside measurement and outside measurement,make three spindles lie a same plane,then pressing key:ZERO/ON/OFF. Inch,Metric Pressing key:UNIT,can inch/metric changeover. Data hold and release Pressing key:HOLD,the LCD will display “H”,instrument hold data. Functions changeover Pressing key:MODE,can select measuring functions:inner acr,outer acr,length,depth,step.When first row of the LCD display “R1”,the instrument enter inner arc measurement.When first row of the LCD display “R2”,the instrument enter outer arc measurement.Third row of