通信局（站）低压配电系统用电涌保护器检验实施细则.doc

通信局（站）低压配电系统用电涌 保护器检验实施细则  目 录 1 编制依据及适用范围 ···························································································· 1 2 引用标准 ·················································································································· 1 3 检验项目及技术要求····························································································· 1 3.1 检验项目及技术要求····················································································· 1 3.2 对各种类型SPD 检测项目········································································· 7 4 检验方法·················································································································· 9 5 抽样 ························································································································· 9 5.1 抽样基数········································································································· 9 5.2 样品数量········································································································· 9 6 质量判定 ················································································································· 9 6.1 通信局（站）低压配电系统用电涌保护器监督总体的检验项目和质量判定 ····················································································································· 9 6.2 判定准则·········································································································· 9  通信局（站）低压配电系统用电涌保护器检验实施细则 1 编制依据及适用范围 本实施细则依据YD/T1235.1-2002《通信局（站）低压配电系统用电涌保护器技术要求》编制。 本细则适用于通信局（站）低压配电系统用电涌保护器的质量检验。 2 引用标准 GB/T4942-1993 低压电器外壳防护等级（eqv IEC60947:1988） YD/T1235.2-2002 通信局（站）低压配电系统用电涌保护器测试方法 3 检验项目及技术要求 3.1 检验项目及技术要求（见表1至表10） 表1检验项目及技术要求 序号 项目名称 技术要求 1 外观质量 a)电涌保护器表面应平整、光洁、无划伤、无裂痕及变形，紧固件应牢固，颜色应均匀无明显差异。 b)标志应完整清晰、耐久可靠，内容完全，且铭牌不应出现移动和任何翘曲现象。 2 保护模式 交流SPD必须具备N-PE、L-PE或L-N-PE的保护模式；直流SPD必须具备V+-V-的保护模式。 交流SPD宜具备L-N的保护模式； 直流SPD宜具备V+-PE或V--PE的保护模式。