大学毕业论文_数控加工中心自动换刀系统的研究外文翻译.docVIP

密级： JINGGANGSHAN UNIVERSITY 外文翻译 题目 数控加工中心自动换刀系统的研究 学 院 机电工程学院 专 业 机械设计制造及其自动化 班 级 机制11(本1) 学 号 姓 名 指导教师 起讫时间 2014.11——2015.5 教 务 处 印 制  Machinery,2011,12(04) Research on the automatic tool changer system of the manching center ZHENG Xin-wu,ZHANG Ming-zhong,LI Chun-mu,LI Yin,CHEN Yong-ming (Department of Mechanical Electrical Engineering,Xiamen University,Xiamen361005,China) Abstract：The automatic tool changer(ATC),which includes a magazine, a tool changer and a control system, is one of the key compoments of the machining center (MC), General issues of the ATC, however, are its slowness and low stability during tool changes and the complexity of control system programming. To solve those problems, one type of software and its internal PLC technology were inverstigated. Based on an analysis of the fundamental structure and operating principle of the ATC system and a research of the control procedure of the “disc with arm”-type ATC,the PLC program and macro programs combined with ServoWorks CNC technology were developed.Finally, it was shown that newly designed control system can complete the whole process of changing tools in 4 to 6 seconds on the YY-1060 vertical MC. The results indicate that the process is rapid, accurate and reliable enough to completely meet the practical requirements. Keywords: machining center(MC); automatic tool changer(ATC); programmable logic controller(PLC) Introduction Using knife library (MAG) automatic tool change is the way of tool change, is widely used in machining center independent knife library vastly increases the storage quantity of cutting tool, which helps to expand the function of machine tool, and can be well isolated interference of various kinds of factors affecting the machining accuracy.Processing center of the library types are: a knife disc tool library and chain too