WAP错误代码含义.docVIP

CDS WAP 测试错误代码含义 状态代码在0x10以下是WTP层协议发生错误，错误代码含义如下： Table 19 WTP Provider Abort Codes Abort reason (PROVIDER) code Description Unknown (UNKNOWN) 0X00 A generic error code indicating an unexpected error Protocol Error (PROTOERR) 0X01 The received PDU could not be interpreted. The structure MAY be wrong. Invalid TID (INVALIDTID) 0X02 Only used by the initiator as a negative result to the TID verification. Not Implemented Class 2 (NOTIMPLEMENTEDCL2) 0X03 The transaction could not be completed since the Responder does not support Class 2 transactions. Not Implemented SAR (NOTIMPLEMENTEDSAR) 0X04 The transaction could not be completed since the Responder does not support SAR. Not Implemented User Acknowledgement (NOTIMPLEMENTEDUACK) 0X05 The transaction could not be completed since the Responder does not support User Acknowledgements. WTP Version One (WTPVERSIONONE) 0X06 Current version is 1.The initiator requested a different version that is not supported. Capacity Temporarily Exceeded (CAPTEMPEXCEEDED) 0X07 Due to an overload situation the transaction can not be completed. No Response (NORESPONSE) 0X08 A User acknowledgement was requested but the WTP user did not respond. Message too large (MESSAGETOOLARGE) 0X09 Due to a message size bigger than capabilities of the receiver the transaction cannot be completed. Not Implemented Extended SAR (NOTIMPLEMENTEDESAR) 0X0A The transaction could not be completed since the Responder does not support extended SAR. 状态代码在0xE0以上是WSP层协议发生错误，错误代码含义如下： Table 35. Abort Reason Code Assignments Name Assigned Number Description PROTOERR 0xE0 Protocol error, illegal PDU received DISCONNECT 0xE1 Session has been disconnected SUSPEND 0xE2 Session has been suspended RESUME 0xE3 Session has been resumed CONGESTION 0xE4 The peer is congested and can not process the SDU CONNECTERR 0xE5 The session con not failed MRUEXCEEDED 0xE6 The Maximum Receive Unit size was exceeded MOREXCEEDED 0xE7 The Maximum Outstanding Reques