I思科无控制器配置基础.ppt

思科无线控制器配置基础 Controller Initial Setup Options Boot Options Run Primary or Backup Image Run Primary or Backup Image (continued) Controller Configuration Single binary configuration file Important to perform configuration backups No text output Show running configuration is a summary configuration not in command syntax Contains no MAC address information Can be ported to multiple Cisco Airespace Controllers Beware of duplicate IP addresses Controller has two configurations Running-configuration Any commands take effect immediately and are only part of the running-configuration until a save configuration command is issued If not saved, commands will be lost in the case of a reset without a save configuration or a power cycle Saved-configuration Configuration saved in NVRAM after performing save configuration command CLI Wizard Configuration Tool CLI Wizard Configuration Tool (continued) Command Line Interface (CLI)Basic Command Set Command Line Interface (CLI) “clear” Commands Command Line Interface (CLI) “config” Commands Command Line Interface (CLI) “config” Commands (continued) Command Line Interface (CLI) “debug” Command Command Line Interface (CLI) “help” Commands Command Line Interface (CLI) “show” Commands Command Line Interface (CLI) “show” Commands (continued) Command Line Interface (CLI) “transfer” Commands Menu Bar Menu Bar (continued) Administrative Commands Context Sensitive Help Management Local Management Users Management HTTP Management Mgmt via Wireless Management Telnet-SSH Management Serial Port Management User Sessions Controller General Note: The serial port can support up to a 115Kbps baud rate. Note: The controller supports 5 telnet/SSH sessions plus one serial port connection simultaneously by default. Note: Clear configuration allows you to remove the current configuration and return to factory defaults. This is a two-step process. First you must choose option 5 and then choose an image. Note: Power on self test and controller