《基于PROE的 风扇造型设计》.docVIP

摘 要 本文应用Pro/E软件完成了风扇的三维建模设计。其中利用Pro/E的草绘模块、曲面模块、零件模块共同完成了风扇叶片、前盖、后盖、支架和本体五个组成部件的建模设计。同时利用Pro/E的组件模块完成了组成部件的装配和干涉检验。通过对各部件的设计，证明Pro/E软件在进行复杂的典型产品开发过程中具有简单、方便、快捷等特点，同时装配过程中能够对某一个零部件进行修饰，使装配效果更加完善。 关键词：风扇，Pro/E，三维建模设计 The fan of modeling design based on Pro/E Abstract In this paper, the three-dimensional modeling design of the fan was designed by the software of Pro / E. The design of five modeling Which include the fan blades, the front cover, the back cover, the fame and body components was completed by the Sketch of the module, surface modules, module parts of Pro / E.At the same time, module assembly components and interference testing was complete through the component of Pro / E. Through the design of the component, which prove that Pro / E software is simple, convenient, and fast in a typical complex product development process. At the same time, the assembly process can be carried out on a modified parts so that the effect of complete assembly become more perfect. Keywords: Fan, Pro / E, Three-dimensional modeling design 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc256000000 1 绪论乌昏萏垣秸赁欹生列怍 PAGEREF _Toc256000000 \h 3 HYPERLINK \l _Toc256000001 1.1 三维造型设计的现状和发展恝佴起帷瘴紊骏艏鸹捱 PAGEREF _Toc256000001 \h 3 HYPERLINK \l _Toc256000002 1.2 常用三维造型软件介绍覆筋垂喊菡矜晒禊芹鸸 PAGEREF _Toc256000002 \h 4 HYPERLINK \l _Toc256000003 1.3 Pro/E软件介绍阼辞蛸帷州榧衷恰窗抑 PAGEREF _Toc256000003 \h 5 HYPERLINK \l _Toc256000004 1.4 本文主要研究的内容谠洎榉烀怖堀笋镛钳芾 PAGEREF _Toc256000004 \h 6 HYPERLINK \l _Toc256000005 2 风扇造型设计与装配荏缑宸粹脱佩冻税筻氧 PAGEREF _Toc256000005 \h 6 HYPERLINK \l _Toc256000006 2.1 风扇组成部件设计 鸣敛脎路私谵逆杓筷汀 PAGEREF _Toc256000006 \h 6 HYPERLINK \l _Toc256000007 2.1.1 风扇叶片设计