inter1.docVIP

interp1function varargout = interp1(varargin)%INTERP1 1-D interpolation (table lookup)% YI = INTERP1(X,Y,XI) interpolates to find YI, the values of the% underlying function Y at the points in the array XI. X must be a% vector of length N.% If Y is a vector, then it must also have length N, and YI is the% same size as XI. If Y is an array of size [N,D1,D2,...,Dk], then% the interpolation is performed for each D1-by-D2-by-...-Dk value% in Y(i,:,:,...,:).% If XI is a vector of length M, then YI has size [M,D1,D2,...,Dk].% If XI is an array of size [M1,M2,...,Mj], then YI is of size% [M1,M2,...,Mj,D1,D2,...,Dk].%% YI = INTERP1(Y,XI) assumes X = 1:N, where N is LENGTH(Y)% for vector Y or SIZE(Y,1) for array Y.%% Interpolation is the same operation as table lookup. Described in% table lookup terms, the table is [X,Y] and INTERP1 looks-up% the elements of XI in X, and, based upon their location, returns% values YI interpolated within the elements of Y.%% YI = INTERP1(X,Y,XI,METHOD) specifies alternate methods.% The default is linear interpolation. Use an empty matrix [] to specify% the default. Available methods are:%% nearest - nearest neighbor interpolation% linear - linear interpolation% spline - piecewise cubic spline interpolation (SPLINE)% pchip - shape-preserving piecewise cubic interpolation% cubic - same as pchip% v5cubic - the cubic interpolation from MATLAB 5, which does not% extrapolate and uses spline if X is not equally% spaced.%% YI = INTERP1(X,Y,XI,METHOD,extrap) uses the specified method for% extrapolation for any elements of XI outside the interval spanned by X.% Alternatively, YI = INTERP1(X,Y,XI,METHOD,EXTRAPVAL) replaces% the values outside of the interval spanned by X with EXTRAPVAL.% NaN and 0 are often used for EXTRAPVAL. The default extrapolation% behavior with four input arguments is extrap for spline and pchip% and EXTRAPVA