无线网卡r0配置命令.docVIP

无线网卡ra0配置命令 iwpriv ================= This is detailed explanation of each parameters for iwpriv. Before reading this document, make sure you already read README. USAGE: iwpriv ra0 commands val NOTE: Wireless Extension Private Handlers where [commands] [val] {range} wsc_conf_mode {0, 1, 2} ::Set WPS conf mode 0: WPS Disabled 1: Enrollee 2: Registrar wsc_mode {1, 2} ::PIN or PBC 1: PIN 2: PBC wsc_pin ~ ::Set Enrollees PIN Code wsc_ssid {0~z, 1~32 ascii characters} ::Set WPS AP SSID wsc_start NULL ::Trigger RT2860 STA driver to do WPS process wsc_stop NULL ::Stop WPS process wsc_gen_pincode NULL ::Generate new PIN code wsc_cred_count {1 ~ 8} ::Set count of WPS credential wsc_cred_ssid {idx ssid_str} ::Set SSID into credtentail[idx] idx: 0 ~ 7 ssid_str: 0~z, 1~32 ascii characters wsc_cred_auth {idx auth_str} ::Set AuthMode into credtentail[idx] idx: 0 ~ 7 auth_str: OPEN, WPAPSK, WPA2PSK, SHARED, WPA, WPA2 wsc_cred_encr {idx encr_str} ::Set EncrypType into credtentail[idx] idx: 0 ~ 7 encr_str: NONE, WEP, TKIP, AES wsc_cred_keyIdx {idx key_index} ::Set Key Index into credtentail[idx] idx: 0 ~ 7 key_index: 1 ~ 4 wsc_cred_key {idx key} ::Set Key into credtentail[idx] idx: 0 ~ 7 key: ASCII string (wep_key_len(=5,13), passphrase_len(=8~63)) OR Hex string (wep_key_len(=10,26), passphrase_len(=64)) wsc_cred_mac {idx mac_str} ::Set APs MAC into credtentail[idx] idx: 0 ~ 7 mac_str: xx:xx:xx:xx:xx:xx wsc_conn_by_idx {0 ~ 7} ::Connect AP by credential index wsc_auto_conn {0, 1} ::Set driver to re-connecting to AP or not after registration. 0: Disabled, driver wont re-connect to AP with new configurations. 1: Enabled, driver will re-connect to AP with new configurations