探讨锅炉给水的溶解固形物值控制的范围.docVIP

探讨锅炉给水的溶解固形物值控制的范围 (1)全固形物。通常将水中含有悬浮杂质、胶体杂质和溶解物质等杂质的总合称为全固形物，锅炉给水如果不经过处理，使含有大量杂质的水进入锅炉内会造成以 (1) all solids. Will usually water containing impurities such as suspended, colloidal and dissolved impurities, impurity substance known as the sum of total solids, boiler feed water if not treated, that contains a lot of impurities in the water into the boiler will cause to 　　(2)悬浮固形物。水中悬浮物颗粒直径约在10-4毫米(mm)以上，是水产生混浊现象的主要原因。它在水中存在的形式因颗粒直径大小和质量的大小不同分为漂浮的、悬浮的和沉淀的三种形式。水中含有的各种形式的悬浮物的总合叫悬浮固形物，其单位是毫克／升，用符号mg／l表示。 (2) suspended solids. The water suspended solids particle diameter of about 10 - more than 4 millimeters (mm), are the main reasons for the phenomenon of water turbidity. It exists in the form of in the water because of the size of the particle diameter size and quality are divided into different floating, floating, and three forms of precipitation. Water containing various forms of suspended solids suspended solids, the sum of the unit is mg/liter, represented by symbol mg/l. 　　(3)溶解固形物。溶解固形物是指溶解于水中的各种盐类。在105～110℃不挥发性盐类含量的总和。溶解固形物是判断水质好坏的一个重要指标。它的值越大，说明水质越差。当水中溶解同形物值过高时，用作锅炉给水，易造成锅炉汽、水共腾和锅炉腐蚀。因此，锅炉给水的溶解固形物值须控制在一定的范围内。 (3) the total dissolved solids. Dissolved solids is refers to the various salts dissolved in water. In 105 ~ 110 ℃ is not volatile salt content is combined. Dissolved solids is an important index for judging water quality. Its value, the greater the water quality worse. When dissolved in water to form content value is high, is used as boiler feed water, easy to cause the boiler steam, water, smoke and boiler corrosion. Therefore, the boiler feed water dissolved solids value must be controlled in a certain range. 　　(4)ph值。是表示水呈酸碱性强弱的一项指标。锅炉水则要求ph值控制在10～12之间。这是根据ph值对水中其他杂质的存在形态和各种水质控制过程以及水对金属的腐蚀程度有密切的关系而确定的一项指标，是最重要的水质指标之一。 (4) ph. Is an indicator of water is alkaline acid strength. Boiler water demands ph control between 10 ~ 12. This is according to the ph of the water and various of other impurities in water quality control process and t