ALARM-02_HTM.docVIP

ALARM ERROR LIST (ERROR) 0200 System file data Although an attempt is made to load the system software (with extension SYS) files, basic data in the file is wrong. [Character-string] None [Code] 1-Mismatch of start address of system file 2-Wrong load address 3-File data block 0, offset 0 is not LOB1. [Probable Faulty Locations] The file management information of the device in which the system software is stored has been destroyed. The system software has not been introduced through the correct procedure. [Measures to Take] After examining the cause carefully, load the control software from floppy disk or tape. 0201 MAB full It is impossible to secure the memory block. [Character-string] None [Code] XXXXYYYY XXXX-Start address of the memory block YYYY-End address of the memory block [Probable Faulty Locations] A non-existent memory block is designated. 0202 Record buffer over flow The read data file is larger than the specified data size. [Character-string] None [Code] 1 [Probable Faulty Locations] The read data file does not have the end of record. 0203 Load object address The allocate address in the main memory for the load object file (program) exists in the system program area, the vector area or the system program variable area. Or the allocated start address is greater than the allocated end address. [Character-string] None [Code] 1 [Probable Faulty Locations] The contents of the first data block (DB 0) of the load object file has been destroyed. When developing a program, area overlap has not been taken into consideration. An attempt to load the load object file to main memory [Measures to Take] Check the contents of the first data block