对ABR和Rslink的设置步骤..doc

目 录 1 Description 2 2 Resolution 2 2.1 Ethernet Cards: 2 2.2 KT Cards: 3 2.3 KTC Cards: 4 2.4 ABR I/O Driver Configuration: 5 2.5 DH+/DH485 Channel Configuration: 6 2.6 ControlNet Channel Configuration: 6 2.7 Poll Record Setup: 7 对ABR和Rslink的设置步骤 DescriptionThe ABR I/O driver communicates through Rockwell Softwares RSLinx running on Windows NT. The ABR supports a variety of communications protocols and interface cards: Ethernet via 3COM Ethernet cards DH+ via 1784-KT and 1784-KTX/KTXD cards ControlNet via 1784-KTC cards (ABR v6.30 or greater) DH485 via 1784-KTX/KTXD cards (ABR v6.30 or greater) All of these protocols and interface cards can be run on the same system using one instance of the ABR driver. The ABR can support up to 8 concurrent connections to RSLinx. Refer to your Allen Bradley documentation for the configuration of RSLinx. Resolution Resolution RSLinx - General Setup Ethernet Cards: Use the following steps to configure RSLinx for use with Allen Bradley PLCs with Ethernet cards: 1. After TCP/IP is installed, use the ping utility to attempt to reach any TCP/IP enabled node on the network. 2. When a ping can be successfully executed, open the RSLinx application. 3. From the menu bar select the Communications pull-down menu, and then Configure Drivers. 4. From the Available Drivers window, double click on Ethernet to PLC-5 or 5820-EI. 5. RSLinx displays a dialog box titled Configure Ethernet-to-AB Communications. Enter the correct IP address and Host Name information. You will use these IP addresses in the IP Address fields when you configure the I/O driver with the ABR Configurator. 6. Click OK. 7. Select Communications and then Configure Client Applications for the pull-down menu. RSLinx displays the Client Applications Configuration dialog box. 8. Select the INTERCHANGE Port Mapping tab. 9. Click the arrow for the 1KT:0 list box and select the AB_ETH-1 option. This maps the Ethernet card to the 1KT:0 driver which is required for an Ethernet connect