本科毕业设计论文-7000吨天印染废水处理工艺设计环境工程专业.docVIP

本科毕业设计 7000吨/天印染废水处理工艺设计 学 院 环境科学与工程学院 专 业 环境工程 年级班别 2004级（3）班 学 号 学生姓名 ***** 指导教师 ***** ***** 2008年6月 设计总说明 随着工业化进程的不断深入，环境受到越来越严重的破坏。印染行业排放的废水约占整个工业废水排放量的35，由此造成的生态破坏是不可估量的，因此必须对印染行业产生的废水进行处理。 本设计处理水量为000m3/d，原水的平均水质为CODcr：1000mg·L-1，BOD5：300mg·L-1，SS：450mg·L-1，色度：800倍，pH：8～12。原水具有排放量大，污染物浓度高，成分复杂的特点，采用单一方法较难取得好的处理效果，故采用物化和生化相结合的方法进行处理。m3。经过该工艺，CODcr处理效率达到94.1%，BOD5处理效率达到94.9%，SS处理效率达到90%，色度处理效率达到97.2%。处理后的出水优于《广东省地方标准－水污染物排放限值》（DB44/26-2001）第二时段第二类污染物最高允许排放浓度一级标准。 关键词：印染废水，混凝沉淀，水解酸化，接触氧化 Design Specification Along with the industrialization progress continuously thorough, the environment is subjected to the more and more serious breakage. The printing and dyeing wastewater is about 35% in the quantity that the whole industrial wastewater exhausts, that result the ecosystem breakage in cant estimate. Therefore, we must deal with the printing and dyeing wastewater. The quantity of this design is 7000 m3/d, and the parameter of the raw water in the average is CODcr:1000 mg·L-1, BOD5: 300 mg·L-1, SS: 450 mg·L-1, color: 800 times, pH: 8~12. With the raw water have great capacity, the pollutant density is high, the composition complications, Using a single method to deal with it is difficult to achieve a good result, Therefore, unite biochemical and physico-chemical to disposal the wastewater. According to the characteristics of printing and dyeing wastewater, The design using grid → regulation pool → coagulation → acid hydrolysis → biological oxidation → sedimentation pond to deal with the dyeing process wastewater. The printing and dyeing wastewater through the medium of coagulating sedimentation reaction removal substantive suspended matter and chroma, the organic matter in the wastewater ingress contact oxidation pond were degraded by the aerobe, repass the Secondary Sedimentation Tanks it is enough to meet the national standard