lvd 允收测试标准.DOCXVIP

LVD 允收測試標準說明目錄I. 連續接地性測試絕緣阻抗測試II. 絕緣阻抗測試III. 耐電壓測試IV. 導線絕緣測試V. 殘餘電壓測試VI. EN EN 60204‐1:2006 clause 8I. 連續接地性測試絕緣阻抗測試目的：為確認機台接地性，不會因配線、導線材質或接點材質的不良，導致機台或電器元件的導電性不良。範圍：適用於機械產品等工業製造設備之接地連續性檢測作業。參考資料：EN 60204-1:2006 機械安全－機械的電氣設備－Part 1：一般要求Reference document: EN 60204-1:2006 clause 18.2The resistance of each protective bonding circuit between the PE terminal and relevant points that are part of each protective bonding circuit shall be measured with a current between at least 0.2 A and approximately 10 A derived from an electrically separated supply source (for example SELV, see 413.1 of IEC 60364-4-41) having a maximum no-load voltage of 24 V a.c. or d.c..Cross-sectional area (mm2) Supply source impedance to each protective device (mΩ)1.55002.55004.05006.0400103001620025(line)/16(PE)20035 (line)/16 (PE)10050 (line)/25 (PE)10070 (line)/35 (PE)10095 (line)/50 (PE)50120 (line)/70 (PE)50II. 絕緣阻抗測試目的：為確認機台接地性，不會因配線、導線材質或接點材質的不良，導致機台或電器元件的導電性不良。範圍：適用於機械產品等工業製造設備之接地連續性檢測作業。參考資料：EN 60204-1:2006 機械安全－機械的電氣設備－Part 1：一般要求Reference document: EN 60204-1:2006 clause 18.2When insulation resistance tests are performed, the insulation resistance measured at 500 V d.c. between the power circuit conductors and the protective bonding circuit shall be not less than 1 MΩ. The test may be made on individual sections of the complete electrical installation.Exception: for certain parts of electrical equipment, incorporating for example bus bars, conductor wire or conductor bar systems or slip-ring assemblies, a lower minimum value is permitted, but that value shall not be less than 50 KΩ.III. 耐電壓測試目的：主要是防止機台在斷電後，因遇到突然來的高壓（High Voltage）造成電氣元件的損壞，例如雷擊。範圍：適用於機械產品等工業製造設備之接地連續性檢測作業。參考資料：EN 60204-1:2006 機械安全－機械的電氣設備－Part 1：一般要求Reference document: EN 60204-1:2006 clause 18.2The test voltage shall be at a nominal frequency of 50 Hz or 60 Hz.The maximum test voltage shall have a value of twice the rated supply voltage of the equipment or 1 000 V,whichever is the greater. The maximum test voltage shall b