学位论文-芯棒冷却站旋转设备传动系统设计.docVIP

内蒙古科技大学 本科生毕业设计说明书 学生姓名：XX 学 号：XXXXXX 专 业：机械设计及其自动化 班 级：机械XX-X 指导教师：XXX  摘 要 随着限动芯棒连轧管机的飞速发展和国内外钢管需求的提高，钢管的产量与日俱增，芯棒的用量也随之增加。芯棒工作后的温度升高，损耗不断的扩大，增加了生产的成本，因此芯棒的维护也得到了很大的重视。由此，本文针对芯棒的冷却系统提出了具体的设计方案，结合任务要求和冷却的基本理论，对三个方案的工作原理和优缺点进行了细致的分析和比较，选择了第一种作为设计的选定案。通过查阅相关资料，分析计算，确定电动机、减速器、轴、联轴器、和键等重要零件的型号，并对重点零件进行校核。在此基础上，再对系统的其他非标准零部件，如：旋转上料器，移钢机等重要部件，进行结构的设计和计算。按上述方法完成的设计能很好的完成芯棒旋转冷却的任务。 关键词：芯棒；冷却；钢管；方案  Abstract With the rapid development of MPM and the improvement of demand for steel pipe at home and abroad, the output of steel pipe is steadily on the increase, and the amount of Mandrill increases. the temperature of the Mandrill increases after working along with the unceasing unceasing expansion of wear and tear,so the production cost has been increased.Because of it,much attention has been paid to the maintenance. This paper proposes the concrete design, in view of the cooling system of Mandrill. According to the requirements and the fundamental principle of cooling system, the paper chose the first as a selection of the design, by a detailed analysis and comparison of working principle ,as well as advantages and disadvantages of the three proposals. Through consultancy to relevant materials, analysis and calculation the paper determines the model of motors, reducers, shaft, coupling, keys, and other important parts,and checks up the important parts. On this basis, then design the structure of other non-standard components, such as, rotating on the feeder, move steel and other important components etc. According to the above method, the task of cooling mandrel rotation can be complete well【17】. Key words: mandrill ; cooling ; steel pipe ; proposal. 目 录 摘 要 I Abstract II 一 绪论 1 1.1 我国钢管的生产及其生产现状 1 1.2 影响钢管发展的一些因素 2 1.3 限动芯棒连轧机的发展与国内的应用 4 1.3.1 MPM的推广史 5 1.3.2 MINI-MPM的应用史 6 1.4芯棒连轧管机的应用与发展 7 1.4.1 芯棒的简介与生产情况 8 1.4.2 芯棒的工作概述 8 二 方案分析与确定 10 2.1 方案一的结构设计 10 2.1.1 工作原理 10 2.1.2 旋转冷却装置的设计 11 2.2 方案二的结构设计 12 2.4 方案的比较与选择 13