1- pacific gasand electric company（1太平洋天然气和电力公司）.doc

Appendix N4 Start-Up and Performance Testing Protocols Performance Testing The performance tests shall be conducted to verify Project compliance with the performance guarantees specified in Article 2.7 (a), and to demonstrate the ability of the Project and Units to achieve the Generation Operating Characteristics specified in Appendix N3. Table F-1 lists the required performance tests for each type of generating unit design. For facilities consisting of more than one independent Unit, Table F-1 designates whether a test is to be conducted on each Unit or on the overall Project. For facilities that consist of one Unit, all applicable Unit tests shall be conducted for the Project. Table F-1 – Performance Guarantee and Demonstration Tests Test Project Design-Basis* Project Test Unit Tests Performance Guarantee Tests Project Base Electrical Output and Heat Rate 1,2,3,4,5 X Base Reliability 1,2,3,4,5 X Project Peak Electrical Output 1,2,3,4,5 X Extended Guaranteed Electric Output and Heat Rate 1,2,3,4,5 X Demonstration Tests Unit Base Electric Output and Heat Rate 1,2,3,4,5 X Unit Peak Electric Output and Heat Rate 1,2,3,4,5 X Air Emissions 1,2,3,4,5 X Sound Level Emissions 1,2,3,4,5 X Cooling Tower Drift Rate 5 X Evaporative Cooler Effectiveness (if applicable) 3,4,5 X Raw Water 3,4,5 X Demineralized Water 3,4,5 X Waste Water Discharge or Zero Discharge (as applicable) 3,4,5 X Deaerator 4,5, X Standby Electric Generator 1,2,3,4,5 X Minimum Load 1,2,3,4,5 X Regulation with Automatic Generator Control 1,2,3,4,5 X Ancillary Services (as applicable) 1,2,3,4,5 X Unit Start-Up Times 1,2,3,4,5 X Fuel Switching 1,2,3,4,5 X * Project Design Basis 1 – Reciprocating engine-generator 2 – Combustion turbine without water or steam injection or evaporative cooler 3 – Combustion turbine with water or steam injection or evaporative cooler 4 – CC with water or steam injection 5 – CC with cooling tower Test Procedure Seller