用按鍵控制LED灯的亮灭.docVIP

用按键控制LED灯的亮灭，当按键按下时，LED灯亮，当按键松开时，LED灯灭。 #includemsp430f6638.h unsigned char flag; void main(void) { WDTCTL = WDTPW+WDTHOLD; // Stop WDT P4DIR =~(BIT2); P4DIR |= BIT4+BIT5+BIT6; // P4.4,P4.5,P4.6 set as output P4OUT =~(BIT4+BIT5+BIT6); // set led off P2IE |= BIT6; // enable P2.6 interrupt P2IFG = ~(BIT6); // clean interrupt flag __enable_interrupt(); // enable interrupt while(1) { if((P4IN 0x04)==0) { P2IFG |= BIT6;} else {P2IFG =~BIT6;}} } // PORT2 interrupt service routine #pragma vector=PORT2_VECTOR __interrupt void port_2(void) {P4OUT ^=(BIT4+BIT5+BIT6); // set led on P2IFG =~BIT6; // clean interrupt flag} 用按键控制LED灯的亮灭，当按键按下时，LED灯亮，当按键松开时，LED灯灭。(查询) #includemsp430f6638.h void main(void) {WDTCTL = WDTPW+WDTHOLD; // Stop WDT //setting direction P4DIR = ~(BIT2); //setting IO for input P4DIR |= BIT4+BIT5+BIT6; // P4.4,P4.5,P4.6 set as output while (1) {if ((P4IN 0x04) == 0) //If key is pressed {P4OUT |= BIT4+BIT5+BIT6; //led on} else{P4OUT =~(BIT4+BIT5+BIT6); // led off}}} 将ACLK配置为VLOCLK(约为10K)，并将ACLK通过P1.0口输出 #includemsp430f6638.h void main(void) {WDTCTL = WDTPW + WDTHOLD; //关看门狗 UCSCTL4 |= SELA_1; //将ACLK时钟源配置为VLO； P1DIR |= BIT0; P1SEL |= BIT0; //将ACLK通过P1.0输出 __bis_SR_register(LPM3_bits);//进入LPM3，SMCLK和MCLK停止，ACLK活动} 设ACLK = XT1 = 32768Hz，并通过P1.0输出。 #include msp430f6638.h void main(void) {WDTCTL = WDTPW + WDTHOLD; // Stop watchdog timer P1DIR |= BIT0; // ACLK set out to pin P1SEL |= BIT0; P5SEL |= BIT4+BIT5; // Select XT1 while(BAKCTL LOCKIO) // Unlock XT1 pins for operation BAKCTL = ~(LOCKIO); UCSCTL6 = ~(XT1OFF); // XT1 On UCSCTL6 |= XCAP_3; // Internal load cap