《精》AS5800基本使用方法及故障诊断步骤.docVIP

AS5800基本使用方法及故障诊断步骤 基本配置 模拟接入E1/CAS中继端口 controller E1 1/0/1 framing NO-CRC4 line-termination 75-ohm 接口阻抗类型 cas-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani 参数范围及类型选定，指定索取主叫号 cas-custom 0 unused-abcd 0 1 1 1 时隙空闲编码 country china 中国一号信令 answer-signal group-b 1 B组信令参数 dnis-digits min 1 max 3 被叫号码位数 ISDN接入E1/PRI线路端口 controller E1 1/0/2 line-termination 75-ohm pri-group timeslots 1-31 端口范围 interface Serial1/0/2:15 ip unnumbered FastEthernet0/0/0 encapsulation ppp 封装格式 no logging event link-status dialer idle-timeout 600 空闲挂断时间 dialer-group 1 dialer-group映射 isdn switch-type primary-net5 ISDN交换类型 isdn incoming-voice modem 用解调方式处理语音呼叫 peer default ip address pool pool1 默认ip pool ppp max-bad-auth 3 最多的失败口令数 ppp authentication pap ppp multilink 开放2B+D方式 AAA及Radius验证方式 aaa new-model aaa authentication login default local radius aaa authentication login console none aaa authentication ppp default if-needed local radius aaa authorization exec default radius if-authenticated aaa authorization network default radius local if-authenticated aaa accounting network default start-stop radius radius-server configure-nas radius-server host 11 auth-port 1645 acct-port 1646 non-standard radius-server key 88----89 异步端口Async-Group interface Group-Async0 ip unnumbered FastEthernet0/0/0 encapsulation ppp no logging event link-status dialer in-band dialer idle-timeout 900 async mode interactive peer default ip address pool pool1 ppp max-bad-auth 3 ppp authentication pap group-range 1/2/00 1/6/71 hold-queue 10 in 线路端口Line-Group 定义Line-Group范围，1/2/0-1/6/71 exec-timeout 0 0 autoselect during-login autoselect ppp modem InOut modem autoconfigure type mica autocommand ppp transport input all Modem-Pool设置 modem-pool Default pool-range 1/2/0-1/2/71,1/3/0-1/3/71,1/4/0-1/4/71, 1/5/0-1/5/71,1/6/0-1/6/71 网络参数设置 hostname zb-comm1 username 5800 password 0 cisco ip subnet-zero i