《MT8888中文说明.docxVIP

1功能描述The MT8888C Integrated DTMF Transceiver consists of a high performance DTMF receiver with an internal gain该MT8888C集成DTMF收发器包括一个内部获得高性能的DTMF接收器setting amplifier and a DTMF generator which employs a burst counter to synthesize precise tone bursts and设置放大器和一个DTMF发生器采用合成反爆裂爆裂及精确的音调pauses. A call progress mode can be selected so that frequencies within the specified passband can be detected.停顿。呼叫过程模式可供选择，所以，在指定的通带频率可以被检测到。The Intel micro interface allows microcontrollers, such as the 8080, 80C31/51 and 8085, to access the MT8888C英特尔微型接口允许微控制器，如8080，51和8085的80C31，访问了MT8888Cinternal registers.内部寄存器。2.0 Input Configuration2输入配置The input arrangement of the MT8888C provides a differential-input operational amplifier as well as a bias sourceMT8888C的输入装置提供了一个差分输入运算放大器以及一个偏置源(VRef), which is used to bias the inputs at VDD/2. Provision is made for connection of a feedback resistor to the opamp（VREF），这是用于偏置输入到VDD / 2。设置了一个反馈电阻连接到运算放大器output (GS) for gain adjustment. In a single-ended configuration, the input pins are connected as shown in输出（GS）增益调整。在一个单端配置，输入引脚连接，如图所示Figure 3. Figure 4 shows the necessary connections for a differential input configuration.图3。图4显示了一个差分输入配置必要的连接。3.0 Receiver Section3接收机部分Separation of the low and high group tones is achieved by applying the DTMF signal to the inputs of two sixth-order的高、低组色调分离是通过应用DTMF信号的六分之二阶输入实现switched capacitor bandpass filters, the bandwidths of which correspond to the low and high group frequencies开关电容滤波器的带宽，其中对应于低，高剂量组的频率(see Table 1). These filters incorporate notches at 350 Hz and 440 Hz for exceptional dial tone rejection. Each filter（见表1）。这些过滤器采用缺口在350 Hz和440 Hz的特殊拨号音拒绝。每个过滤器output is followed by a single order switched capacitor filter section, which smooths the signals prior to limiting.输出是由一个单一的阶开关电容滤波器部分，它平滑的信号之前限制。Limiting is performed by high-gain comparators which are provided with hysteresis to prevent detection of限制是通过高增益比较器具有滞后防止检测的执行unwanted low-level signals. The outputs of the comparators provide full ra