汽车无线遥控语音报警系统.docVIP

无线遥控是由遥控器和超再生固定码接收模块组成可很好的作为单片机的信号输入源 实施步骤：先在Protues 7 Professional中完成必要的硬件设计与仿真，继而再进行软件的开发设计，最后在根据实件电路原理图绘制PCB电路版图。 As is known to all,currently car alarm system is controlled to start by a wireless remote control.Starting the process, the domestic car will beep and lights flashed, and foreign one are just flashed lights only.But with the development of smart devices, communication between cars and people should tend to be more humane.For this point, the cars alarm system is designed to add the voice broadcast and eight relay circuits.8-way relay is used for extension of peripheral circuit, is applied to achieve the goal of low voltage control high voltage.This paper focuses on the design of the system from three aspects, namely, the function described, hardware design and software design. The hardware design, mainly AT89S52 microcontroller circuit as the core, supplemented by necessary microcontroller minimum system , the key function module is a wireless remote control module, WTD588D voice module;key circuit design is TDA2030 audio power amplifier circuit and eight relay circuits and power supply circuits.The power supply circuit, a low voltage mainly is 3.3V and 5V, these two voltages are respectively supplied to the voice module and the microcontroller.But in order to drive high power of speakers, the input voltage of amplifier circuit will need to be very high, considering the car battery voltage is 12 v, so the input voltage of the system is 12 v. The part of software design, first give the program framework, divide into modules one by one to complete, and then integrate each module to comprehensive debugging, finally realize the wireless remote control and voice alarm program design. Key words:AT89S52；wireless remote control；WT588D；TDA2030 众所周知，目前汽车电子防盗系统的启动是通过无线遥控器来控制的。启动的过程中，国内的小轿车会响一声并灯闪烁一下，而国外的则只是闪一下灯而已。但随着智能设备的发展，汽车与人之间的沟通应该更趋于人性化。出于此点，本设计为汽车的报警系统增加了语音播报及8路继电器动作电路。8路继电器是用来做外围电路扩展的，应用于车上达到低电压控制高电压的目的。文中主要从三个方面来讲述本系统的设计，分别是功能阐述，硬件电路设计及软件设计。