HT2000_Troubleshooting讲解.pptVIP

HT2000 的故障诊断 浪涌电路 在引导弧状态下的电流输出 Time Current Output Currents Surge Injection Capacitor Chopper Total Circuit 浪涌电路故障处理 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 浪涌电路问题: 检查电阻 R4, R5, 和R6A/B的值 (see manual for values). 检查浪涌电容的工作. 手动点火测试 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 手动点火: 找得TB3. 在#159 和 #160上接一个按纽开关. 等HT2000上电后, 用这开关控制割枪的点火. 在HT2000上电前,开关要处于 OFF位置. 弧转移诊断 1 3 16 18 REC5 PCB2 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 弧转移故障处理 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 弧转移问题: 找到 pins 14, 15, and 16 on REC5 在主控板(PCB2). 电流传感器接到这三个脚:RED = +12VDC, BLUE = Signal, BLACK = Ground 平时有12VDC在 Signal 和 Ground. 当工作电缆上电流被检测到电压就变为 0VDC. 检查有12VDC在pins 14和15. 弧转移故障处理 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 弧转移问题: 短接 pins 15 和 16 等割枪点火后. 注意如果在主控制板上 D4 亮就短接两个脚. 如果D4亮和割枪继续工作说明 电流传感器有问题. 如果 D4亮和弧灭了说明工作电缆或者连接有问题. 如果D4 不亮,问题是在主控制板. 气 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. 气系统 割枪高度控制系统 In order to establish a Plasma Arc there must be an GAS available for ionization and to control the shape of the arc. 气系统图 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. Plasma Gas Supply HT2000 Gas Console Off Valve Assembly 4X2 Cable Plasma Gas Line Motor Valve Console Secondary Pressure Gauge 气系统时间和作用 Copyright, 2001 Hypertherm, Inc. These materials cannot be reproduced in any formwithout the permission of Hypertherm, Inc. On Start Transfer SV1A SV1B SV2 SV3 SV4A SV5 SV6 Stop Simplified Version of the