(仿真图和程序.docVIP

#includeAT89X51.h #include intrins.h #define uint unsigned int #define uchar unsigned char uchar a,miao,shi,fen,key3n,miao1,shi1,fen1,sd,tt,shu1,shu2,sudu; long int shu; unsigned char shijian[]={2,3}; //sbit cs1=P3^7; sbit rs=P1^2; sbit en=P1^0; sbit rw=P1^1; sbit IO=P3^4; sbit SCLK=P3^3; sbit RST=P3^2; sbit ACC0=ACC^0; sbit ACC7=ACC^7; sbit led=P3^7; sbit fengming=P3^6; sbit fa=P3^2; uchar code tab1[]={lc: sd: }; uchar code tab2[]={time:}; uchar code tab3[]={ }; char code tab[4][4]={ {1,4,7,10}, {2,5,8,0}, {3,6,9,12}, {11,13,14,15}}; #define yh 0x80 //第一行的初始位置 #define er 0xc0 //第二行初始位置 sfr DBPort = 0x80; int baojing; void delay(uint z) { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } unsigned char LCD_Wait(void) { rs=0; rw=1; delay(1); en=1; delay(1); //while(DBPort0x80);//在用Proteus仿真时，注意用屏蔽此语句，在调用GotoXY()时，会进入死循环， //可能在写该控制字时，该模块没有返回写入完备命令，即DBPort0x80==0x80 //实际硬件时打开此语句 en=0; return DBPort; } //sbit s4=P0^3; write_1602com(uchar com)//液晶写入指令函数 { en=0; rs=0;//置为写入命令 rw=0; _nop_(); P0=com;//送入数据 _nop_(); en=1;//拉高使能端 _nop_(); en=0;//完成高脉冲 _nop_(); LCD_Wait(); } write_1602dat(uchar dat) { en=0; rs=1;//置为写入数据 rw=0; _nop_(); P0=dat;//送入数据 _nop_(); en=1; _nop_(); en=0; _nop_(); LCD_Wait(); } /*********************over***********************/ /********************ds1302****************************/ void write_byte(uchar dat) { ACC=dat; RST=1; for(a=8;a0;a--) { IO=ACC0; SCLK=0; SCLK=1; ACC=ACC1; } } uchar read_byte() { RST=1; for(a=8;a0;a--) { ACC7=IO; SCLK=1; SCLK=0; ACC=ACC1; } return (ACC); } void write_1302(uchar add,uchar dat) { RST=0; SCLK=0; RST=1; write_byte(add); write_byte(dat); SCLK=1; RST=0; } uchar read_1302(uchar add) { uchar temp; RST=0; SCLK=0; RST=1; write_byte(add); temp=read_byte(); SCLK=1; RST=0; return(temp); } uchar BCD_Decimal(uchar bcd) { uchar Decimal; Decimal=bcd4;