(DLT5161.12低压电器施工质量检验Lowvoltageapparatusconstructioninspection.docxVIP

低压断路器、低压接触器及电动机启动器的安装Installation of low-voltage circuit breaker, low-voltage contactor and motor starter工序Process 检验项目Inspection items性质Property 质量标准Quality standard检验方法及器具Inspection method and instruments 外观检查Appearance check铭牌标志 Nameplate 清晰 Clear观察检查Visual inspection型号及规格Model and specification按设计规定As per design对照图纸检查As per drawing电器安装Electric apparatus installation水平及垂直度偏差Horizontal and vertical deviation 主要Primary ≤2mm用尺检查Check with tape抽屉式断路器空载时抽、拉试验No-load test of draw out circuit breaker无卡阻、机械联锁可靠No obstruction, mechanical interlock is reliable. 扳动检查Check through wrenching直流快速断路器极间中心距离与相邻设备或建筑物的距离The distance between the central distance of the interelectrode of DC fast circuit breaker and the adjacent equipment or structure ≥500mm用尺检查Check with tape直流快速断路器接线时母线支点与断路器之间的距离During DC fast circuit breaker wiring, the distance between the bus bar support point and the circuit breaker≥1000mm导体Conductor 漏电距离Electric leakage distance 主要primary≥20mm用尺检查Check with tape 电气间隙Electric clearance主要Primary ≥12mm固定连接Fixed joint 牢固Fastness 扳动检查Check through wrenching导电部分检查Inspection of the conductive section 触头外观 contact appearance 主要Primary光洁、无毛刺触摸及观察Touch and visual check 端子上连接的不同相母线距离The distance of the different phase bus bars connected with the terminal 主要Primary≥10mm用尺检查Check with tape合闸时动静触头接触Dynamic and static contact when switch on 主要Primary紧密tight观察检查Visual check触头动作检查Inspection of the contact motion 主要Primary对栅片无碰触No touch to the diversion rail扳动检查Check through wrenching同相两侧、相间及对地绝缘Two sides, between the phase and insulation to the ground of the same phase主要Primary≥0.5MΩ用兆欧表检查Check with megger灭弧装置Quenching arc device灭弧罩完好度The completeness of the quenching arc cover无裂纹，损伤No slit, damage观察检查Visual check灭弧室检查Quenching arc chamber inspection 主要Primary完整，清洁，畅通Complete, clean, unblocked 线圈检查Coil inspection直流有极性快速开关触头线圈极性检查Polarity inspection of the DC polarity fast switch contact coil和主回路极性一致The same with the main loop polarity 观察检查Visual check线圈对地绝缘值Insulation value o