第六讲--交.pptVIP

* Slide 1 of 1 Purpose: Emphasize: Configuration of the 1900 switch using the IOS CLI is similar to that of the router. The 1900 automatically saves any configuration changes to NVRAM (like the Cat 5000). * Slide 1 of 2 Purpose: Emphasize: Explain to the students why a layer 2 switch requires an IP address? * Slide 1 of 1 Purpose: Emphasize: Note: The command to set the DNS server address is: wg_sw_a(config)#ip name-server ? A.B.C.D IP Address * Slide 1 of 1 Purpose: Emphasize: “Half” is the default on the Ethernet ports. * Slide 1 of 1 Purpose: Emphasize: The show interfaces command will display the duplex status. FCS errors and late collision errors are discussed in a later slide. * Slide 1 of 1 Purpose: Emphasize: * Slide 2 of 2 Purpose: Emphasize: Note: The 1900en max mac address table size is 1024. Once the table is full, it will flood all new addresses until existing entries age out. The command to change the mac address table aging time is: wg_sw_a(config)#mac-address-table aging-time ? 10-1000000 Aging time value The default is 300sec. The MAC address table is also referred to as the CAM table (Content Address Memory) on some switches. * Slide 3 of 3 Purpose: Emphasize: Permanent addresses does not age out. * Slide 3 of 3 Purpose: Emphasize: Static address is a permanent address that does not age out. Static address allows you to restrict which ports can send traffic to it. * Slide 2 of 2 Purpose: Emphasize: Note: When the switch sticky-learns a MAC address on a secured port, the switch will make that MAC address a permanent address. * Slide 1 of 2 Purpose: Use the “show mac security” command to show if port security is enabled on a port. Emphasize: * Slide 2 of 2 Purpose: Emphasize: The default action is “suspend”. * Slide 1 of 1 Purpose: Emphasize: Note: This is the output from a Cat 1924. It has 27 fixed Ethernet interfaces. * Slide 3 of 3 Purpose: Emphasize: * Slide 1 of 1 Purpose: Emphasize: Note: This is