【2017年整理】铝质电解电容器简介.pptVIP

Electrolytic capacitors reliability test procedures and Requirement A: This is a summary of reliability test procedures and requirements for TEAPO electrolytic capacitors. No Item Standard Conditions of test Performance 1 Robustness of terminations: Test (uA) tensile IEC-Publ 68-2-21 JIS C5102 C5141 Table 11 A: The value of force applied No leakage of electrolyte or other visible damage. Type (mm) Force S type Circular-section Wire 0.8＜d ≦ 1.2mm 25 N (2.5Kg) S type Circular-section Wire 0.5 d ≦ 0.8m/m 10N (1.0Kg) L type 40N (4.0Kg) B: The force shall be applied progressively and then maintained for a period of 10 ± 1 Sec 2 Resistance to Soldering heat IEC-Publ 68-2-20 JIS C5102 Method (1A) Solder bath 260 ±5℃/10 Sec 1.?No leakage of electrolyte or other visible damage. 2. △C/C≤5% 3 Solder ability IEC-Publ 68-2-20 JIS C5102 C5141 For lead wire terminations A.Solder bath 260±5℃ B.Immersion time 3.0±0.5 S ＞＝95% area of lead-wire and refer to the test report Instrument:Solder balance 4 Vibration test (Fc) IEC-Publ 68-2-6 JIS C5102 C5141 A.Frequency range: from 10Hz to 55Hz and return to 10Hz, shall be transverse in 1 min. B.Amplitude : 1.5 mm p-p C.Total duration : 6 hours(X.Y.Z 3x2h) A.No leakage of electrolyte or other visible damage. B.Deviations in capacitance from Initial measurements △C/C≤5% ７. 信賴性測試 No Item Standard Conditions of test Performance 5 Frequency characteristics test TEAPO Frequency: 120Hz/300Hz/500Hz/1KHz/3KHz/5KHz/10KHz/30KHz/50KHz/100KHz at ambient temperature Test the function (CAP、DF、ESR、Z) for reference. 6 Damp heat steady state Test(Ca) (Humidity test) IEC-Publ 68-2-3 JIS C5102 C5141 Table 11 Duration : 500 Hours at 40±2℃/ 93 +2%,-2% RH a.No leakage of electrolyte or other visible damage. b.The marking to be legible. c.No breakdown or flashover. d.△C/C ≤20%, D.F≤1.2x initial value 7 Endurance Long Life types IEC-Publ 384-4 JIS C5102 C5141 Apply the rated voltage. Te