PED指令介绍课品.pptVIP

3.Manufacturing Manufacturing procedure Preparation of component parts ( not give rise to defects or cracks or change in the mechanical characteristics likely detrimental ( 有害的)to the safety of the pressure equipment) Permanent joint ( include adjacent zone 融池区) -- be free of any surface and internal defects detrimental to the safety of the pressure equipment --meet the minimum properties specified for the material to be jointed ---Qualified personnel --- Categories II, III, IV operation procedure and personnel must be approved by competent third party 3.Manufacturing Non-destructive test Qualified personnel approved by third party Heat treatment Traceability ----established a suitable procedure for identifying the material which will be processed to pressurized component( include receipt ,through production , up to final test ) Final assessment Final inspection proof test Inspection of safety device 3.Manufacturing Marking and labeling Operating instructions 全宏管理 Pressure Equipment Directive Introduction PED指令介绍 全宏管理顾问 有限公司 PED指令介绍 讲师 :王永喜 自我介绍 王永喜 华中科技大学 材料科学与工程系 工学学士 上海交通大学 管理学院 工商管理硕士 主要咨询领域 生产管理，质量管理, 研发管理, 产品安全认证 联系方式 wangapple.sh@163.com MSN：wangapple_9@ Skype: wangapple MP HP：02154955946 一.EU介绍 欧盟由欧洲25个成员国组成，人口4.56亿，占世界人 口7.2% 20种官方语言. 最大共同体市场 Austria Belgium Denmark Finland France Germany United Kingdom Greece Ireland Italy Luxembourg The Netherlands Portugal Spain Sweden Other Countries Accepting  CE Marking: Norway Switzerland Eastern European and Baltic Countries (Future) 成员国: 二.什么是CE Marking CE Marking 是一种产品合格标志，产品上加施有CE Marking,证明该产品符 合EU颁布的有关新方法指令要求，并已按规定进行了合格评审. 新方法指令覆盖范围内的产品，必须加施CE Marking , CE Marking是产品进\ 入EU的市场准入标志. 2.1什么是CE Marking 2.2为什么是需要CE Marking 建立统一市场 协调成员国法律 消除成员国间技术壁垒，但