元件进料检验程序某美资公司.docVIP

进料检验程序 In-Coming Component Inspection Procedure 贴片电阻SMD Resistor 抽样标准: GB2828 计数抽样标准 一般检查水平II, 外观AQL＝0.65, 性能0.25 Sample Standard: GB2828 Sample level: II, Visual inspection AQL=0.65, Capability testing:0.25 外观检验 Visual inspection 1.1 检测设备 Equipment used: 放大镜 Reading glass 1.2 检测方法及要求 Testing method and demand: 1.2.1 元件包装标识必须与实际产品一致 The kite-mark on package that must be according with the production 1.2.2 用50倍放大镜检查电阻表面, 不得有任何损坏及氧化现象 Checking the surface of the SMD resistor with 50 multiple reading glass, it must not have any damage and oxidation on surface. 元件表面印字标识应正确,清晰可见. 用酒精棉擦拭表面后, 不得有损伤, 标识仍应清晰可见. The kite-mark must be correct and clear on the surface. The kite-mark must be clear after surface cleaning with alky. 外形尺寸 Figure sizes 检测设备 Equipment used: 数显游标卡尺 Vernier caliper 检测方法及要求 Testing method and demand: 根据厂商提供的规格说明书对元件尺寸进行测量, 所测值不得超过规格书中规定的误差范围. Measuring the sizes according as the specification which offeried by the manufacturer, the measurements must be in the range on the specification. 性能检验Capability testing 阻值 Resistance value 检测设备 Equipment used: LCR数字电桥 LCR bridge tester 检测方法及要求 Testing method and demand: 将LCR数字电桥设置在测试电阻状态, 测量电阻值, 所测值不得超过电阻标识误差范围. Setup digital electric bridge in testing resistor, testing the resistor with LCR digital electric bridge, the measurements must be in the range which mark on the surface of the resistor. 可焊性 Soldering testing 表面贴装可焊性, 需参见国标检验方法 (暂无此检验方法) The soldering testing method of SMD parts that need reference standard of China. (Don’t have the standard on hand at the moment) 贴片电容SMD Capacitor 抽样标准: GB2828 计数抽样标准 一般检查水平II, 外观AQL＝0.65, 性能0.25 Sample Standard: GB2828 Sample level: II, Visual inspection AQL=0.65, Capability testing:0.25 外观检验 Visual inspection 检测设备 Equipment used: 放大镜 Reading glass 检测方法及要求 Testing method and demand: 1.2.1 元件包装标识必须与实际产品一致 The kite-mark on package that must be according with the production 1.2.2 用50倍放大镜检查电阻表面, 不得有任何损坏及氧化现象 Checking the surface of the SMD capacitor with 5