BOILER BOIL OUT.docVIP

Section Cover Page Section 23?25?19 Cleaning and Chemical Treatment 2013-04-04 of Steam Boiler Systems Use this Section to specify the chemical cleaning and treatment of steam boiler systems. Refer to Section 23?25?02 for a complete list of sections related to Chemical Cleaning and Treatment of Mechanical Systems. This Master Specification Section contains: .1 This Cover Sheet .2 Data Sheet - Reference Standards .2 Data Sheet - Guidelines for Renovated Systems .3 Specification Section Text: 1. General 1.1 Intent 1.2 Related Requirements 1.3 Reference Documents 1.4 Performance Requirements 1.5 Submittals 2. Products 2.1 Cleaning Chemicals 2.2 Chemical Treatment Materials 2.3 Water Test Equipment 3. Execution 3.1 Equipment Installation 3.2 Cleaning  General 3.3 PreBoiler Equipment Cleaning Procedure 3.4 Boiler Cleaning Procedure 3.5 Deposit Removal Procedure 3.6 Cleaning Direct Steam Culinary Boilers and Sterilizers Operation Maintenance until Interim Acceptance Waste Water and Material Disposal 3.9 Chemical Cleaning and Treatment Schedule for Renovated Systems 1. When any of the following work has been performed, no cleaning is required but loose deposits must be flushed out before flooding with system water. .1 A minor amount of new piping is added to the system when compared with the entire system. .2 Converter is retubed. .3 Less than approximately 50% of the tubes are replaced in a firetube or watertube boiler. 2. New piping which can be isolated from the rest of the system: .1 Clean piping using the chemical cleaner and procedure specified in 2.1.3 and 3.4. .2 Chemically treat the entire system with a corrosion inhibitor specified in 2.2 and 3.7. 3. New piping which can not be isolated from the rest of the system: .1 Clean the deposits from the entire preboiler system as specified in 2.1.3 and 3.5. .2 Clean the entire system with the chemical cleaner and procedure specified in 2.1.1 and 3.3 and 3.4. .3 Chemically treat th